The Imp PCB board allows you to use two separate PCBs such as a MC Cthulhu or XBOX360 game pad PCB with just one USB or RJ45 outgoing cable.  This second-generation PCB gives you control over which PCB is selected by an assigned control button; pressing the button while plugging the console or USB cable into the desired console will save the connection setting.  You won't need to change that setting until you choose another console; again plug into the new console with the button held down and you are good to go.

Many combinations.  One solution.

• The Imp V2 PCB can auto-detect two separate USB-based gamepad boards; such as PS3 or XBOX360. Switching between consoles is as easy as holding the assigned control while plugging into the console of choice.
• The Imp can also connect to a PS3 Cthulhu+ (upgraded Toodles Chimp PCB) and switch to XBOX360 PCB when plugged into the XB360 console.
• When used with a MC Cthulhu PCB, the Imp can detect an XBOX360 gamepad PCB and the multi-console PCB.  A space to solder a RJ45 Jack PCB Mount directly on the Imp allows you to connect to the MC Cthulhu, accessing the several legacy consoles available on this PCB. 

The Imp V2 also contains a space for a USB Jack PCB mount plus spots for direct soldering of USB wires, with power regulation of both RJ45 and USB connections managed directly on the chip.  

Online Install Guide.  Broad Support.

Thorough documentation that details the installation and wiring scenarios are available online at http://www.godlikecontrols.com/imp2.pdf. Ample support is available on the official Toodles Imp V2 forums on shoryuken.com.  Also check out informative videos listed here.

Note: Focusattack.com does not provide technical support for this or any PCB and electronic equipment available at the store.  Please check the support resources for more information or assistance.

If you're an experienced builder, adding the Imp V2 PCB to the MC Cthulhu and XBOX360 gamepad mod will definitely meet your needs for the ultimate joystick.